✓ UK based & passionate✓ Fast UK dispatch✓ Secure checkout✓ Dedicated support
Usually dispatched within 1-3 working days
Batch print 14 challenge coins at once on your xTool O1 Omni, with every coin held in exactly the right place. Drop the jig into the Omni Bracket System, load your blanks, run Pixel-Scan, and print the lot in one pass.
What's Included
1x Challenge Coin Jig (holds 14x 40mm coins)
Requires the Omni Bracket System, sold separately. One bracket set works with the entire L3D jig range. If you already own it, you're ready to go.
Specs & Compatibility
Fits: ALL editions of the xTool O1 Omni (Single UV, Dual-Head UV, UV + DT Fabric)
Capacity: 14 coins per run
Coin size: 40mm challenge coins
Material: 3D printed matte white PLA, colour matched to the O1 Omni
Designed and tested: by Chris on a real O1 Omni in the UK
Designed for 40mm diameter challenge coins. The linked xTool blanks fit perfectly. Please measure your coins before ordering: coins larger than 40mm will not fit, and noticeably smaller coins may sit loose.
Product Features
14 coins in one pass. Stop printing coins one at a time. Load the full jig and let the O1 Omni do the work.
Repeatable alignment. The jig always drops into the brackets in the same position, so your design lines up run after run.
Quick-swap system. Finished with coins? Lift the jig out and drop in any other L3D jig in seconds. No tools, no re-alignment.
Pixel-Scan friendly. The matte white surface scans cleanly under the O1 Omni's vision system.
Please Note
Jigs are 3D printed to order. Minor surface texture from the printing process is normal and does not affect performance. Coins shown in photos are for demonstration and are not included.
