xTool F2 Ultra stainless steel settings

Yes, with the right settings. Slow speeds and full power let a blue diode anneal a permanent dark mark, while infrared and fiber modules mark stainless faster and more cleanly. The settings here say which module each recipe was tested with.

Running slightly out of focus spreads the beam and heats the surface more evenly, which is how the deep black annealed look is achieved. Where a recipe needs it, the offset is listed on the card.

Materials vary between batches and suppliers, machines drift, and focus matters. Treat every number here as a proven starting point, run a small test first, then adjust in small steps.