L3D Laser Library › F1 › Aluminium

xTool F1 aluminium settings

7 tried and tested anodized and bare aluminium settings for the xTool F1, covering anodized. Every recipe here has been run on a real F1 in the L3D workshop before being added, with prep tips and notes where they matter.

Every machine is slightly different. Treat these as proven starting points and always run a small test first.
F1 Blue diode

LED Pens (All colours)

Engrave · All colours

50%
Power
500
Speed mm/s
140
LPC
1
Pass
Anodized Vector · Jarvis
Perfect jig for this: Metal Pen Jig →
L3D-F1-014L3D Accessories Laser Library
F1 Infrared

Bison River Knife Handle (Blue)

Engrave · Blue

80%
Power
250
Speed mm/s
750
DPI
1
Pass
Anodized Photo / bitmap · Jarvis
L3D-F1-022L3D Accessories Laser Library
F1 Infrared

Bison River Button Lock (Black)

Engrave · Black

100%
Power
250
Speed mm/s
750
DPI
1
Pass
Anodized Photo / bitmap · Jarvis
L3D-F1-023L3D Accessories Laser Library
F1 Infrared

Bison River Rescue Knife Handle (Red)

Engrave · Red

90%
Power
150
Speed mm/s
300
LPC
1
Pass
Anodized Vector
L3D-F1-024L3D Accessories Laser Library
F1 Infrared

AR Magazine (Black)

Engrave · Black

100%
Power
1000
Speed mm/s
220
LPC
1
Pass
Anodized Vector
L3D-F1-026L3D Accessories Laser Library

Unlock all 7 aluminium settings

Create a free L3D account to see every tested F1 setting on this page, with prep tips and notes. No card needed, just an email.

Create a free account or log in

Free forever, no card needed. By creating an account you agree to receive member emails from L3D: new tested settings, early access to new jigs, and member-only tips. Unsubscribe at any time.

F1 + aluminium: common questions

Why does anodized aluminium engrave so brightly?

The laser removes the coloured anodized layer to reveal the bare metal underneath, so the mark comes out silver white against the colour. It is one of the most forgiving materials to engrave.

Do different anodized colours need different settings?

Mostly no, which is why several recipes here are marked all colours. Very light colours sometimes want a touch more power for even contrast, so test first on a spare piece.

Why do my results look different to yours?

Materials vary between batches and suppliers, machines drift, and focus matters. Treat every number here as a proven starting point, run a small test first, then adjust in small steps.

← Back to the full Laser Library