L3D Laser Library › F1 › Glass

xTool F1 glass settings

7 tried and tested glass and crystal settings for the xTool F1, covering glassware and ornament. Every recipe here has been run on a real F1 in the L3D workshop before being added, with prep tips and notes where they matter.

Every machine is slightly different. Treat these as proven starting points and always run a small test first.
F1 Blue diode

Pint Glass (Clear)

Engrave · Clear

1-80%
Power
400
Speed mm/s
600
DPI
1
Pass
Glassware Photo / bitmap

Levelled using a jig, works up to 45mm wide. Apply a thin coat of black tempera paint before engraving.

L3D-F1-010L3D Accessories Laser Library
F1 Blue diode

Glass

Engrave

95%
Power
120
Speed mm/s
140
LPC
1
Pass
Glassware VectorRotary

Apply a thin coat of black tempera paint before engraving.

L3D-F1-012L3D Accessories Laser Library
F1 Blue diode

Glass (Photo engraving)

Engrave · Photo engraving

90%
Power
450
Speed mm/s
400
DPI
1
Pass
Glassware Photo / bitmapRotary

Apply a thin coat of black tempera paint before engraving.

L3D-F1-015L3D Accessories Laser Library
F1 Infrared

Glass Ornament (Blue, green, red)

Engrave · Blue, green, red

86%
Power
400
Speed mm/s
300
LPC
1
Pass
Ornament VectorRotary
L3D-F1-028L3D Accessories Laser Library

Unlock all 7 glass settings

Create a free L3D account to see every tested F1 setting on this page, with prep tips and notes. No card needed, just an email.

Create a free account or log in

Free forever, no card needed. By creating an account you agree to receive member emails from L3D: new tested settings, early access to new jigs, and member-only tips. Unsubscribe at any time.

F1 + glass: common questions

Why do glass recipes mention tempera paint or dish soap?

A thin coating helps the surface absorb the laser energy evenly, which stops chipping and gives a smoother frosted finish. It washes straight off afterwards.

Can I engrave curved glassware without a rotary?

Narrow designs up to roughly 40mm wide often work on a curved surface laid flat, and several recipes here note that approach. For full wraps you will want the rotary attachment.

Why do my results look different to yours?

Materials vary between batches and suppliers, machines drift, and focus matters. Treat every number here as a proven starting point, run a small test first, then adjust in small steps.

← Back to the full Laser Library