L3D Laser Library › F1 › Plastic

xTool F1 plastic settings

4 tried and tested plastic and polymer settings for the xTool F1, covering rubber, polymer (mags), plastic pens and consumer electronics. Every recipe here has been run on a real F1 in the L3D workshop before being added, with prep tips and notes where they matter.

Every machine is slightly different. Treat these as proven starting points and always run a small test first.
F1 Blue diode

Plastic Pens (Black, blue, green)

Engrave · Black, blue, green

100%
Power
500
Speed mm/s
140
LPC
1
Pass
Plastic pens Vector
Perfect jig for this: Metal Pen Jig →
L3D-F1-009L3D Accessories Laser Library
F1 Blue diode

Rubber Hockey Puck (Black)

Engrave · Black

85%
Power
100
Speed mm/s
140
LPC
2
Passes
Rubber Vector
L3D-F1-004L3D Accessories Laser Library
F1 Blue diode

Polymer Magazine (PMAG)

Engrave

40%
Power
525
Speed mm/s
300
LPC
1
Pass
Polymer (mags) Vector
L3D-F1-007L3D Accessories Laser Library
F1 Blue diode

AirPods Case

Engrave

100%
Power
400
Speed mm/s
120
LPC
1
Pass
Consumer electronics Vector
L3D-F1-035L3D Accessories Laser Library

Unlock all 4 plastic settings

Create a free L3D account to see every tested F1 setting on this page, with prep tips and notes. No card needed, just an email.

Create a free account or log in

Free forever, no card needed. By creating an account you agree to receive member emails from L3D: new tested settings, early access to new jigs, and member-only tips. Unsubscribe at any time.

F1 + plastic: common questions

Is it safe to engrave any plastic?

No. Stick to known laser safe plastics like the ones in these recipes and never engrave PVC or vinyl, which release corrosive gas that damages lungs and machines.

Why do dark plastics engrave lighter?

Many dark polymers turn pale where the laser melts the surface, which is what recipes marked engraves white or engraves tan rely on for contrast.

Why do my results look different to yours?

Materials vary between batches and suppliers, machines drift, and focus matters. Treat every number here as a proven starting point, run a small test first, then adjust in small steps.

← Back to the full Laser Library