L3D Laser Library › F1 › Stainless Steel

xTool F1 stainless steel settings

5 tried and tested stainless steel settings for the xTool F1, covering drinkware (bare), polished, knife & gun steel and brushed. Every recipe here has been run on a real F1 in the L3D workshop before being added, with prep tips and notes where they matter.

Every machine is slightly different. Treat these as proven starting points and always run a small test first.
F1 Infrared

Stainless Steel Mug

Engrave

100%
Power
50
Speed mm/s
300
LPC
1
Pass
Drinkware (bare) VectorRotary
L3D-F1-001L3D Accessories Laser Library
F1 Infrared

Stainless Steel (Polished)

Engrave · Polished

100%
Power
5
Speed mm/s
300
LPC
2
Passes
Polished Vector
L3D-F1-006L3D Accessories Laser Library
F1 Infrared

Bison River Knife Blade (Black)

Engrave · Black

100%
Power
400
Speed mm/s
300
LPC
1
Pass
Knife & gun steel Vector
L3D-F1-021L3D Accessories Laser Library
F1 Infrared

Bison River Knife Blade (Stainless)

Engrave · Stainless

100%
Power
5
Speed mm/s
300
LPC
1
Pass
Knife & gun steel Vector
L3D-F1-025L3D Accessories Laser Library
F1 Infrared

Stainless Steel (Brushed)

Engrave · Brushed

100%
Power
30
Speed mm/s
220
LPC
1
Pass
Brushed Vector
L3D-F1-027L3D Accessories Laser Library

Unlock all 5 stainless steel settings

Create a free L3D account to see every tested F1 setting on this page, with prep tips and notes. No card needed, just an email.

Create a free account or log in

Free forever, no card needed. By creating an account you agree to receive member emails from L3D: new tested settings, early access to new jigs, and member-only tips. Unsubscribe at any time.

F1 + stainless steel: common questions

Can a diode laser really mark stainless steel?

Yes, with the right settings. Slow speeds and full power let a blue diode anneal a permanent dark mark, while infrared and fiber modules mark stainless faster and more cleanly. The settings here say which module each recipe was tested with.

Why do some stainless recipes use a focus offset?

Running slightly out of focus spreads the beam and heats the surface more evenly, which is how the deep black annealed look is achieved. Where a recipe needs it, the offset is listed on the card.

Why do my results look different to yours?

Materials vary between batches and suppliers, machines drift, and focus matters. Treat every number here as a proven starting point, run a small test first, then adjust in small steps.

← Back to the full Laser Library